KKT KOLBE IND5904FZ Bedienungsanleitung Seite 49

Installation
approved type and provide a 3 mm air gap contact separation in all poles (or in
all active [phase] conductors if the local wiring rules allow for this variation of the
requirements)
• The isolating switch will be easily accessible to the customer with the hob ins-
talled
• You consult local building authorities and by-laws if in doubt regarding installa-
tion
• You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the
wall surfaces surrounding the hob.
Before locating the fixing brackets
The unit should be placed on a stable, smooth surface
(use the packaging). Do not apply force onto the cont-
rols protruding from the hob.
Adjusting the bracket position
Fix the hob on the work surface by screw 4 brackets on
the bottom of hob(see picture) after installation.
Cautions
• The ceramic cooker hob must be installed by qualified personnel or
technicians.
• The hob will not be installed directly above a dishwasher, fridge, freezer,
washing machine or clothes dryer, as the humidity may damage the hob
electronics
• The induction hotplate shall be installed such that better heat radiation
can be ensured to enhance its reliability.
• The wall and induced heating zone above the table surface shall with-
stand heat.
• To avoid any damage, the sandwich layer and adhesive must be resistant
to heat.
Bracket
!
49