Philips HR2181/10 Gebrauchsanweisung Seite 10

EnglisH
10
Question Answer
What does When you push the pulse switch to PULSE and hold it
'pulse' mean? in this position, the appliance runs at its highest speed.
As soon as you release the pulse switch, the switch
jumps back to its original position. When the blender
was set to PULSE from the pulse-activation position P,
it stops when you release the pulse switch. When the
blender operated at speed 1 to 4, it starts to run
again at this speed when you release the pulse switch.
The pulse switch gives you more control over the
processing job and is also very useful when you want
to process ingredients very briefly.
The pulse Check if the appliance is plugged in and the speed
switch does not selector is in pulse-activation position P. You can also
work. What use the pulse switch when the speed selector is set to
should I do? a speed between 1 and 4. The pulse switch does not
work when the speed selector is set to the off
position 0 or to speed 5.
What is the When the speed selector is set to AUTO, the
AUTO setting blender automatically speeds up to the maximum
of the speed speed within 15 seconds and then keeps running
selector for? at the maximum speed.
Can I pour No, let the liquids or ingredients cool down to
boiling hot 80°C/175°F to avoid damage to the blender jar.
liquids into the
blender jar?
Why does the It is very common for a new appliance to give off an
motor produce unpleasant smell or emit some smoke the first few
an unpleasant times it is used. This phenomenon stops after you have
smell during used the appliance a number of times. The appliance
processing? may also give off an unpleasant smell or emit some
smoke if it has been used too long. In that case, switch
off the appliance and let it cool down for 60 minutes.
Question Answer
The appliance Switch off the appliance and unplug it. Then use a
stopped spatula to dislodge the ingredients that block the
running because blades. If you were processing a large quantity, pour
the blades are some of the ingredients out of the blender jar before
blocked. What you switch on the blender again.
should I do?