Stop&Go Function; Recall Function; Keep Warm » Function; Bridge Function - Novy 1700 Montageanleitung Und Bedienungsanleitung

Stop&Go function
This function brakes all the hob's cooking activity temporarily and allows restarting with the same
settings.

 Startup/stop the pause function :
Action
Engage pause
Stop the pause

Recall Function

After switching off the hob (0/I), it is possible to recall the last settings.
 cooking stages of all cooking zones (power)
 minutes and seconds of programmed cooking zone-related timers
 Keep warm function
The recall procedure is following:
 Press the key [0/I]
 Then simultaneously press the 2 zones back in less than 6 seconds.
The previous settings are again active.
« Keep warm » Function
This function allows to reach and maintain automatically a temperature of 42°C or 70°C.
This will avoid liquids overflowing and fast burning at the bottom of the pan.
 To engage, to start the function « Keep warm » :
Action
Zone selection
42°C to engage
70°C to engage
To stop
This function can be started independently on all the heating zones.
When the pan leaves the cooking zone the "Keep warm" function remains active during
approximately 10 minutes.
The maximum duration of keeping warm is 2 hours.

Bridge Function

This function allows to use the 2 cooking zones at the left at same time with the same features as
a single cooking zone. Power function isn't allowed.
Action
Activate the hob
Activate the bridge
Increase bridge
Stop the bridge
Control panel
Simultaneously press
the 2 rear cooking zones
Simultaneously press
the 2 rear cooking zones,
re-press the blinking display
Control panel
Press display [ 0 ] selected
Press on key [ U ]
Press on key [ U ]
Slide on the "SLIDER"
Control panel
Press display [ 0/I ]
Press on the 2 cooking zones left
Slide on the "SLIDER "
[ 1 to 9 ] or display [ U ]
Press on the 2 cooking zones links
54
Display
[ II ]
[ II ] blinking
Previous setting
on display
Display
[ 0 ] to [ 9 ] or [ H ]
[ ]
U
[ U ]
[ 0 ] to [ 9 ] or [ H ]
Display
[ 0 ] or [ H ]
[ 0 ] appears on the before
area
[ ∏ ] on the rear zone.
[ 1 to 9 ] or [ U ]
[ 0 ] or [ H ] on the 2 zones