Cobra MARINE Bedienungsanleitung Seite 32

Bedienung VHF Marine Radio Protocols
MEM Icon
26 Deutsch
Erweiterter Betrieb
1 . Press the MEM/ESC button . The MEM icon will be
turned On .
2 . Press the Channel Up/Down button to select the
memory location . If a memory location has been
programmed, its associated channel will display
on the LCD . Your radio is now in Marine Standby
mode on the selected memory location .
To Exit Memory Location Mode:
Press the MEM/ESC button to return the radio to
Marine Standby mode . The last channel used in
Marine Standby mode will now be displayed on
the LCD and the MEM icon will disappear .
To Erase Stored Memory Locations:
1 . Press and hold the MEM/ESC button for two (2)
seconds . The memory location number will start
flashing and the MEM icon will be turned On .
2 . Use the Channel Up/Down button to advance to
the memory location you want to erase .
3 . Press the MEM/ESC button to select the memory
location . The memory channel number will
stop flashing and the channel number will start
flashing .
4 . Use the Channel Up/Down button to change to
the channel to read "00" at the selected memory
location .
5 . Press the MEM/ESC button to erase that channel .
Repeat steps 2 through 5 to erase as many additional
memories as you want .
6 . Press and hold the MEM/ESC button for two (2)
seconds . This will return the radio to Memory
mode .
7 . Press and release the MEM/ESC button again to
return to Marine Standby mode .