Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
What's in the Box
• MAC 410 Head Unit
• External Microphone
• Power / Speaker Harness
• Hardware Bag
• Single DIN Sleeve
• Trim Ring
• Owner's Manual
• Installation Guide
• HDMI cable
• Remote Control
Disconnecting the Battery
To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to
installation.
NOTE: If the MAC 410 is to be installed in a car equipped with an on-board drive or navigation computer, do
not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under
these conditions, use extra caution during installation to avoid causing a short circuit.
Pre-installation
1. Put the 2 brackets between mounting sleeve and
the head-unit. Remove the sleeve.
2. Install the mounting sleeve:
a. Install mounting sleeve into the dashboard or
optional adapter. Do not force the sleeve into the
opening or cause it to bend or bow.
b. Locate the series of bend-tabs along the top,
bottom and sides of the mounting sleeve. With
the sleeve fully inserted into the dashboard
opening, bend as many of the tabs outward as
necessary so that the sleeve is frmly secured to
the dashboard.
c. Install the support strap to make the unit more
stable.
3. Place the radio in front of the dashboard opening
so the wiring can be brought through the moun-
ting sleeve.
CAUTION!
Be careful not to damage the car
wiring.
WARNING! Never install this unit where operation and viewing could interfere with safe driving conditions.
Tools and Supplies
You will need these tools and supplies for installation:
• Torx type, fat-head and Philips screwdrivers
• Wire cutters and strippers
• Tools to remove existing radio (screw driver, socket
wrench set or other tools)
• Electrical tape
• Crimping tool
• Volt meter/test light
• Crimp connections
• 18 gauge wire for power connections
• 16 – 18 gauge speaker wire
Removal Keys
Dashboard
2b
TAB
DASHBOARD
5 5
2c
2a
TAB
DASHBOARD
Werbung
Inhaltsverzeichnis
