OK. OPD 420 Gebrauchsanleitung Seite 43

Size - A5
IMPORTANT SAFETY INSTRUCTIONS. READ CAREFULLY AND KEEP FOR FUTURE
REFERENCE.
• Risk of electric shock! Do not open.
• CAUTION: To prevent the risk of electric shock, do not remove cover (or back). No
user-serviceable parts inside. Refer servicing to authorised service agent.
• For safety reasons, this class II device is provided with double or reinforced
insulation as indicated by this symbol.
• The lightning flash with arrowhead within an equilateral triangle is intended to
alert the user to the presence of uninsulated "dangerous voltage" inside the
enclosure of this device, which may be of sufficient magnitude to constitute a
risk of electric shock to persons.
• The exclamation point within an equilateral triangle is intended to alert the
user to the presence of important operating and maintenance instructions in
the literature accompanying this device
• Before connecting the device to a socket outlet, make sure the voltage indicated on
the device corresponds to your local mains.
• The mains plug or device coupler is the disconnecting device. It shall remain readily
operable.
• If the supply cord is damaged, it must be replaced by the manufacturer or its
authorised service agent or similarly qualified person in order to avoid hazard.
• WARNING! To reduce the risk of fire or electric shock, do not expose this device to
rain or moisture. Protect from dripping or splashing. Do not place any objects filled
with liquids, such as vases, on the device.
• Regularly check if the supply cord, device or extension cable are defective. If found
defective, do not put device into operation. Immediately pull the plug.
• Place the supply cord and, if necessary, an extension cable in such a way that pulling
or tripping over it is impossible. Do not allow the supply cord to hang down within
easy reach.
• Do not jam, bend or pull the supply cord over sharp edges.
• Protect the supply cord from being walked on or pinched particularly at the plug,
convenience receptacles and the point where it exits from the device.
• Never pull the plug by the supply cord or with wet hands.
• Disconnect the mains plug in case of faults during use, during lightening storms,
before cleaning and when not using the device for a longer period of time.
• In case of malfunction due to electrostatic discharge, reset the device by removing
the mains plug from the socket outlet.
• Refer all servicing to authorised service agent. Do not attempt to repair the device
yourself. Servicing is required when the device has been damaged in any way, such
as the supply cord or plug are damaged, liquid has been spilled, objects have fallen
into the device, the enclosure is damaged, the device has been exposed to rain or
moisture, does not operate normally, or has been dropped.
• WARNING! To prevent injury, devices for wall-mounting must be securely attached
in accordance with the installation instructions in the user manual. Improper
installation may render the device unsafe.
OPD420_A5_DE_EL_EN_ES_130527.indb 43
43
EN
27/5/13 1:52 PM