Napoleon PRO665 Handbuch Seite 17

Problem Possible Causes
Infrared burner (if equipped) Ceramic tiles overloaded with
flashes back (during grease drippings and build-up.
operation the burner Ports are clogged.
abruptly makes a loud
"whoosh" sound, followed
by a continuous blow-torch Burner overheated due to
type sound and grows dim.) inadequate ventilation (too much
grill surface covered by griddle or
pan.)
Cracked ceramic tile.
Leaking gasket surrounding the
ceramic tile, or a weld failure in the
burner housing.
Electronic Ignition not Unit not connected to power.
working.
Blown Fuse.
Faulty transformer.
Terminals on switch or circuit
board are corroded or loose.
Faulty igniter.
Dirty or corroded electrodes.
Oven and control panel lights Unit not connected to power.
not working
Blown fuse.
Faulty transformer.
Terminals on switch or circuit
board are corroded or loose.
Bulbs blown (oven lights only).
Solution
Turn burner off and allow to cool for at least
two minutes. Relight burner and burn on high
for at least five minutes or until the ceramic
tiles are evenly glowing red.
Ensure that no more than 75% of the grill
surface is covered by objects or accessories.
Turn burner off and allow to cool for at least
two minutes, then relight.
Allow burner to cool and inspect very closely
for cracks. If any cracks are found, contact
your authorized Napoleon dealer to order a
replacement burner assembly.
Contact your authorized Napoleon dealer for
instructions on ordering a replacement burner
assembly.
Plug power cord into a working GFI protected
outlet.
Replace fuse located on outlet line of
transformer.
Check transformer output – should be 12VAC.
Replace if required.
Clean connections and ensure connectors
are pushed together firmly. Access to circuit
board is under electrical cover on left side of
cabinet.
Replace igniter – located under electrical
cover.
Clean or replace as required.
Plug power cord into a working GFI protected
outlet.
Replace fuse located on outlet line of
transformer.
Check transformer output – should be 12VAC.
Replace if required.
Clean connections and ensure connectors
are pushed together firmly. Access to circuit
board is under electrical cover on left side of
cabinet.
Replace bulbs as per the instructions in the
maintenance section of the manual.
www.napoleongrills.com
17
EN