KII AUDIO Kii THREE Bedienungsanleitung Seite 11

SELECT SWITCH - this three position mini switch selects whether the XLR Input functions as an analog
c
input for this individual speaker, or if either the right or left channel of the AES signal will be played by
this speaker.
P/R button - (RESET)
d
Press and hold the button for 5 seconds, this resets the speaker.
(The front LEDs will indicate this by blinking briefly in violet color)
P/R button - (LATENCY MODE)
A short press of the button will switch the Kii THREE into low latency mode.
This allows to achieve lip-sync of the audio to picture, when used alongside a TV or beamer.
Pressing the button again switches the speaker back into normal mode.
For the best listening experience (without picture), make sure the speaker is set to normal mode.
(The front LEDs will indicate this by ONE red LED lighting up - low latency mode,
or TWO red LEDs lighting up - normal mode)
Kiilink - Input and Thru (or Output) - When a digital input (AES) is used, both channels of the
e
stereo signal will be sent together via a single digital cable from your source.
You simply choose the speaker that is located closest to your digital source and connect the AES cable
to its input, this is now the „master speaker" while we call the other one the „slave speaker". The slave
speaker gets its signal directly from the master speaker.
Both speakers are connected with the supplied CAT5 cable. Simply plug it into the right CAT5 port
(labeled „Thru") of your master speaker and into the left CAT5 port (labeled „In") of your slave speaker.
11