KII AUDIO Kii THREE Bedienungsanleitung Seite 10

Installation + Connector Panel
a
b
c
d
Power - The Kii THREE has no power switch. Simply plug the power cable into the IEC socket
If no audio signal is present at the input for more than 15 minutes,
the speaker will automatically go into standby mode.
As soon as the input detects any audio signal (analog or digital) it will automatically power on.
This can take up to seven seconds.
Here is an overview of the connector panel from left to right:
SERIAL NUMBER - This is the individual Serial No. for each speaker.
a
XLR INPUT - This is the single XLR Input connector which can be set to process analog or digital audio
b
signals, depending on how the Select switch (c) is set.
10
Input Select In
R Dig L
Boundary
Analog
P/R
free wall
corner
Kiilink Thru 230V~
b
B
a
F f
s
C
c
Contour
Ff F
120V~200W
f
.
e
f
Boundary