Start-Up And Use; Starting The Dishwasher; Loading The Detergent; Washing Options - Scholtes lvx 12-46 Bedienungsanleitung

Start-up and use

Starting the dishwasher

1. Turn the water tap on.
2. Press the ON/OFF button: the indicator light will
illuminate.
3. Open the door and pour in a suitable amount of
detergent ( see below ).
4. Load the racks ( see Loading the racks ) and shut
the door.
5. Select the desired wash cycle depending on the
dishes and how dirty they are ( see table of
wash cycles ), by turning the knob clockwise.
6. Select the wash options ( see below ).
7. After a few minutes the cycle start and the
WASH CYCLE PHASE indicator lights display
the status of the cycle:
Pre-wash, Wash,
8. At the end of the cycle two short beeps will
sound and the DRYING indicator light will flash.
9. Turn the knob anti-clokwise to RESET in order to
reset all the settings.
10.Switch off the appliance by pressing the ON/
OFF button, shut off the water tap and unplug
the appliance from the electricity socket.
11.Open the door and wait for a few minutes
before removing the crockery, in order to avoid
burns. Unload the racks, beginning with the
lower level.
Modifying the duration of a wash cycle already
in progress
If a mistake was made during the wash cycle
selection process it is possible to change the
cycle, provided that it has only just begun: turn
the knob anti-clockwise until it reaches the RESET
position. After a few seconds one long beep and
three short beeps, the WASH CYCLE PHASE
indicator light will switch off: select the new cycle.
Adding extra crockery
Press the ON/OFF button and open the door,
taking care to avoid the escaping steam, and
place the crockery inside the dishwasher. Press
the ON/OFF button again: the cycle starts from the
point at which it was interrupted.
Accidental interruptions
If the door is opened during the wash cycle, or if
there is a power cut, the cycle stops. It starts
again from the point at which it was interrupted
once the door has been shut or the electricity
supply is restored.
Rinse, Drying.

Loading the detergent

A successful wash also depends on the correct
amount of detergent being used, as recommended
by the manufacturer. Exceeding the recommended
amount does not result in a more effective wash
and pollutes the environment.
compartment A: Washing detergent
compartment B: Pre-wash detergent
D
A
B
C
cycle requires 1 tablet, place it in compartment A
and close the cover; when it requires 2, place the
second tablet at the bottom of the appliance.
3. Remove detergent residues from the edges of
the compartment and close the cover until it clicks.

Washing options*

All-in-one tablets*
When using multi-use tablets (2-in-1, 3-in-1, 4-in-1
etc.), press the all-in-one tablets button. This option
optimises the results of the wash. The overall
duration of the programme increases by
approximately 10 minutes.
 This option is not recommended for use with wash
cycles which do not specify the use of multi-use
tablets ( see table of wash cycles ).
* Only available in selected models.
1. Open cover C by
pressing button D.
2. Pour in the detergent
after consulting the
Wash cycle table :
• for powder detergent
use compartments A
and B
• for tablets, use
compartment A and the
bottom of the
appliance, i.e. when the
17
EN