Herunterladen Inhalt Inhalt Diese Seite drucken

Chimney Fire; Cleaning And Maintaining Your Wood-Burning Stove - wiking Olympic Installations- Und Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

In the table below you'll find your wood-burning stove's nominal output, which is to be used to
properly dimension your chimney.
Nominal output:
Smoke temperature:
Exhaust gas mass flow:
After a longer period of disuse
If you have not used your wood-burning stove in a while (e.g. for an entire summer season), it
is important to check for blockage in the chimney duct. Contact your local chimney sweep.
Connecting several heating sources to the same chimney
It is possible to connect several units to some chimneys. All applicable regulations must first
be consulted, in your building code and with your local chimney sweep.

Chimney fire

In the event of a chimney fire:
Close all dampers in the stove and chimney and immediately call the fire department.
Before using the wood-burning stove again, your local chimney sweep must first inspect the
chimney.

Cleaning and Maintaining Your Wood-Burning Stove

Warning: Cleaning and maintenance of your wood-burning stove may only be performed
when it is cool.
External cleaning
The outside of your stove can be dusted as needed with a soft cloth or dust brush.
Cleaning the glass door
Your WIKING wood-burning stove is equipped with a pane-flush system, which reduces the
build-up of soot on the glass. If soot somehow accumulates on the pane, it can be cleaned by
wiping the glass with a moist paper towel dipped in ash. Afterwards, dry with a clean paper
towel. You should also ensure that air gaps in the door frame are free of ash and soot particles.
Also ensure that the seals on the stove are soft and fully intact; if they are not, "false" air can
enter the stove, which makes it more difficult to control combustion and can in turn cause
overheating or soot accumulation. Faulty or worn seals should therefore be replaced and can
be purchased at your local wood-burning stove dealer.
Emptying the ash pan
Important:
Be aware that embers in the ash can remain hot for up to 24 hours after the fire in the stove
has gone out!
The ash pan is most easily emptied by pulling a waste bag over the pan, turning the pan upside
down, and then carefully pulling it up and out of the bag again.
7 kW according to EN norm
285
o
C
8, g/sek.
English
3

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für wiking Olympic

Inhaltsverzeichnis