Installation Instructions; Before You Start - wiking Olympic Installations- Und Bedienungsanleitung

Installation Instructions

Before You Start

Figure  is a cross-sectional view of your wood-burning stove.
Here you can gain an overview of the parts of which your stove
consists.
Steel smoke deflector.
.
Vermiculite smoke deflector.
2.
3. Air intake on the rear plate.
4. Vermiculite rear plate.
5. Vermiculite base plate.
6. Cast iron base grate.
7. Vermiculite log trap.
8. Air-regulation damper.
Please note: The combustion chamber is covered with plates made
of vermiculite, which is a heat-insulating material. These plates ensure that the optimal com-
bustion temperature is quickly reached, and they must therefore remain inside in the wood-
burning stove.
The two smoke deflectors ensure that the passage of smoke through the stove is as long as
possible, so that the flue gasses have more time to emit their warmth within the stove and the
surrounding area. In this way you get more warmth from the wood you add to the stove, as the
warm smoke is not simply sent out through the chimney.
Arrangement of individual components
It is important to ensure that all individual components are in place to no damage was done to
them during transport. In Figure  you can see where the parts should be located in the stove.
The individual components that you must inspect are:
The steel smoke deflector must hang on the two hooks at the top of the wood-burning stove.
.
The vermiculite smoke deflector should rest on the side plates and be pushed all the way
2.
back in the combustion chamber.
3. The rear plate must be pushed all the way back in the combustion chamber.
The divided base plate must lie flat on the bottom around the grate.
4.
Once you are sure that the individual components are in place, you may begin with the instal-
lation of the wood-burning stove.
English
1
2
3
4
6
5
Abb. 1
23
7
8