Replacing The Lamp; Closing The Door - AEG SCB41811LS Benutzerhandbuch

Problem
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.

7.2 Replacing the lamp

CAUTION!
Disconnect the plug from
the mains socket.
1. Pull the left side of the lamp cover
with your fingers to unlock it. Remove
the cover by pulling it towards
yourself.
2
Possible cause
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been
opened often.
There is no cold air circula-
tion in the appliance.
1
1
Solution
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Make sure that there is cold air
circulation in the appliance.
2. Replace the lamp with one of the
same power and shape, specifically
designed for household appliances.
The maximum power is shown on the
light bulb cover.
3. Install the lamp cover.
4. Connect the plug to the mains
socket.
5. Open the door.
Make sure that the light switches on.

7.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
ENGLISH 27