Installation - SEVERIN KS 9798 Gebrauchsanweisung

Before using for the fi rst time
∙ Remove any exterior and interior packaging materials
completely, including the transport securing devices.
∙ The packaging materials must be properly disposed of.
∙ NOTE: When the door to the freezer unit is opened, a small
red component will fall out; this is for transport only and can
be disposed of.
∙ Fit the two spacer elements
(1, provided) into the
corresponding guide slots
(2) on the rear.
∙ Before it is connected to
the mains, the unit must
be thoroughly checked for
transport damage, including its power cord.
∙ Clean the unit as described in the section De-frosting and
cleaning.
∙ When the unit is fi rst switched on, a slight 'new' smell may
be noticed. However, this will disappear once the cooling
process has begun.
14

Installation

∙ The appliance should be set up in a well-ventilated, dry room.
∙ It should be operated in conditions where the relative
humidity is no more than 70 %.
∙ Refrigeration appliances are classifi ed into certain
climate classes. This classifi cation indicates the ambient
temperature at which the device can be operated. Please
refer to the product data sheet for information on the
classifi cation for this unit; the data sheet can be found at the
end of this manual.
∙ Do not use the appliance outdoors.
∙ Ensure that the plug is accessible and can be removed from
the wall socket at any time.
∙ Do not expose the appliance to direct sunlight, and do not
position it next to any heat sources (radiators, cookers etc). If
this cannot be avoided, however, suitable insulation must be in
installed between the heat source and the unit.
∙ The unit must not be installed inside a cabinet, nor directly
below a hanging cupboard, shelf or similar object.
∙ In the case of uneven fl oors, the adjustable front feet on the
unit can be used to compensate and ensure optimum stability.