Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Initial LED Display
nAFA
NAFL
3-Sound Activated Mode
The unit responds to sounds picked up by the unit in microphone to create a light show . Each sound
picked up makes changes to color shown and position of the effects. This mode enables the unit to act
a Master to other Slave units
Choosing Sound Activated
To select, use the "MODE/ESC" button and choose "NStS". When the "ENTER" button is pressed the
LED Display changes to "SrUn" and the unit enters Sound Activated Mode.
Initial LED Display
NStS
4- Slave Mode
Up-to 32 units can be daisy chained together with one single unit acting as Master and all other linked units
as Slaves. Slave units will all run in synch with the master unit without the need for an additional controller.
Connections can be made using standard DMX control cables with Master unit running in Auto Run or
Sound Activated Modes an placed at the start of the chain
Choosing Slave Mode
To select, use the "MODE/ESC" button and choose "SLAu". When the "ENTER" button is pressed the LED
display changes to "Son" and the unit will be slaved to control signals coming from a Master unit
5- Service Modes
After major configuration changes it may be necessary to reboot or reset the unit.
Resetting the Unit
To select, use the "MODE/ESC" button and choose "rEST"(restore). Press "ENTER" to confirm. The unit
powers itself down and then on again for a few seconds. During this time the LED display will scroll "rEST"
from left to right, after which normal operation recommences.
Second LED Display
Fast
SloU
Second LED Display
SrUn
16
Sub-mode
Fast Auto Run
Slow Auto Run
Sub-mode
Sound Activated
Werbung
