Lightmaxx LIG0010511-000 Bedienungsanleitung Seite 13

3.2 Fixture linking
You will need a serial data link to run light show of one or more fixtures using a DMX-512
controller or to run synchronized on two or more fixtures set to a master/slave operating mode.
The combined number of channels required by all the fixtures on a serial data link determines
the number of fixtures the data link can support.
Maximum recommended serial data link distance: 500 meters (1640ft).
Maximum recommended number of fixtures on a serial data link: 32 fixtures.
Data cabling
To link fixtures together you must obtain data cables. If you choose to create your own cable
please use data-grade cables that can carry a high quality signal and are less prone to
electromagnetic interference.
3.3 3-Pin to 5-Pin conversion chart
Note! If you use a controller with a 5 pin DMX output connector. you will need to use a 5pin to
3 pin
CHAUVET Model No: DMX 5M or DMX 5F
The chart below details a proper cable conversion:
3.4 Setting up a DMX serial data link
13