Lightmaxx LIG0009643-000 Bedienungsanleitung Seite 12

3 TILT
4 TILT FINE
5 PAN/TILT SPEED
6 DIMMER & STROBE
7 Rot
8 Grün
9 Blau
10 Farb Makros
11 Farb MIX Geschwindigkeit
12 AUTO Modus (AUTO & SOUND EFFECT)
4 channel mode:
Channel Function
1 PAN
2 Tilt
3 Dimmer/Strobe
4 Color Macros
3. Set up
Disconnect the power cord before replacing a fuse and always replace with the
same type fuse.
Power Supply: Before plugging your unit in, be sure the source voltage in your area matches the
required voltage for your. The Light is available in a 110v to 250v version. Because line voltage
may vary from venue to venue, you should be sure your unit voltage matches the wall outlet
voltage before attempting to operate you fixture.
3.1 Fuse replacement
With a flat head screwdriver wedge the fuse hold out of its housing. Remove the damaged
fuse from its holder and replace with exact same type fuse. Insert the fuse holder back in its
place and reconnect power.
3.2 Fixture linking
You will need a serial data link to run light show of one or more fixtures using a DMX-512
controller or to run synchronized on two or more fixtures set to a master/slave operating mode.
12