dtm NANO II Betriebsanleitung Seite 13

2.4. Entering Galactic authentication code to receiver (available only for NANO2 868, NANO2 DUO versions)
To enter an authentication code to receiver it is necessary to have remote with programmed authentication code by
GPROG programmer.
To enter an authentication code to receiver press the C1 button twice. LED starts blinking for 8 seconds. During this time press and
hold for 5 seconds two buttons of the remote. Successful entering of the code indicates the C1 LED that blinks three times. From
that moment the receiver has authentication code set and programmable remotes with Galactic function can be added.
If within 8 seconds after pressing C1 button twice, the code is not entered, or code entering fails, the LED will not blink three times
but immediately light up.
x2
1 2
PRESS TWICE
C1 BUTTON
Fig. 4. Entering Galactic authentication code to receiver.
The frequency of the LED blinking after double pressing the C1 button of the receiver informs whether the authentication code is
set.
A very fast blinking (10 blinks per second) informs that the Galactic code is not set in the receiver.
A slow blink (1 blink per second) informs that the Galactic authentication code is set in the receiver.
2.5. Removing Galactic authentication code from the receiver (available only for NANO2 868, NANO2 DUO versions)
To remove the authentication code it is necessary to have a remote which the code has been entered.
To remove the authentication code press C1 button twice. LED goes out for 8 seconds. During this time press and hold two
buttons of the remote. Successful removing of the code indicates the C1 LEDs blink three times. If within 8 seconds after pressing
C1 button twice, the code is not removed, or code removing fails, the LED will not blink three times but immediately light up.
Memory format removes the authentication code from receiver.
2.6. Adding a remote with the use of Galactic function (available only for NANO2 868, NANO2 DUO versions)
To add remote with the use of Galactic function, authentication codes of the receiver and remote must be compatible.
To add the remote press and hold for 5 seconds two buttons of the remote, in receiver radio range. Successful adding is indicated
by C1 LED three blinks. To activate the remote at the receiver's memory, press any button on the remote.
5s
1 2
IN REMOTE RADIO
RANGE
Fig. 5. Adding a remote with Galactic function
Failure in registering may be caused by:
incompatibility of authentication codes in receiver and remote,
ź
low battery of the remote,
ź
radio interference during the procedure,
ź
full memory of the receiver.
ź
REMOTE WITH GALACTIC
PRESS AND HOLD FOR 5s
3
C1 STARTS BLINKING
TWO BUTTONS
FOR 8 SECONDS
OF THE REMOTE CONTROL
REMOTE WITH
x3
GALACTIC
C1 BLINKS x3
PRESS FOR 5 SECONDS
3
TWO BUTTONS REMOTE ADDING
SUCCESSFUL
OF THE REMOTE
x3
CODE
C1 BLINKS x3
4
- CODE ENTERING
SUCCESSFUL
EN