General Information; Technical Data; Available Functions - dtm NANO II Betriebsanleitung

GENERAL INFORMATION

The series of 1-channel radio receivers NANO2 is designed to work with gate controllers, roller shutters and other automation
devices where a control pulse is required. It allows, in a simple and cost-effective way, to extend the installation functionality with
a remote control.

TECHNICAL DATA

MEMORY
FREQUENCY
POWER SUPPLY
POWER CONSUMPTION
OUTPUT
OUTPUT LOAD
OPERATION MODE
TEMPERATURE
INGRESS PROTECTION
DIMENSIONS
DIMENSIONS WITH BRACKETS

AVAILABLE FUNCTIONS

EASY REMOTE ADDING
EASY REMOTE ADDING LOCK
GALACTIC FUNCTION
VERIFYING NUMBER OF REMOTES
MANAGEMENT VIA MEMO
1. Installation
Receiver is designed for use inside buildings or inside
other automation devices. Ensure proper operation
condidtions in line with technical parameters. Do not
mount in locations exposed to high humidity and
frequent sudden temperature changes.
Due to the externally accesible screw connection
provide galvanic isolation from other devices and wires.
Attention should be paid to thermal insulation of
a u t o m a t i o n e l e m e n t s w h i c h c a n r e a c h h i g h
temperatures (motors, transformers, circuits
implementing, heat sink etc.). For electrical connection
see Fig. 1.
Factory wire antenna is connected to antenna terminal.
Optionally external antenna can be used. Connect
external antenna with 50Ω impedance coaxial cable to
- center core, - shield.
15 remotes 15 remotes 150 remotes
DTM433MHz DTM433MHz
+ other
producers
433MHz
Approx. 30mA (with relay ON)
monostable, turn-on time 1s
only DTM433MHz
Fig. 1. View of the receiver
with pin description.
150 remotes 200 remotes
DTM433MHz DTM433MHz DTM868MHz
+ other
producers
12...24V AC/DC ±10%
one, separated NO type
1A/24V AC/DC
-20°C /+55°C
IP-20
42x23x50 mm
42x23x71 mm
only DTM433MHz
C
NO
200 remotes
DTM433MHz
+
DTM868MHz
433MHz
868MHz
and 868MHz
only DTM868MHz
C1 programming
button with LED
USB socket
cover
pin description
12-24V
power antenna
EN