Hama Delta Solid 2/4 Bedienungsanleitung Seite 2

L L
Operating Instructions
»Delta Solid 2/4«
Battery Fast Charger
Charging
2
Ready
➀ ➁
➂ ➃
B
C
oder/or
oder/or
Mains adapter: 100 - 240 V/ 50-60 Hz/ 7 W
battery type
AAA Micro
AA Mignon
AA Mignon
• Batteries with a lower capacity than shown in the table should not be
charged because of the high charging current.
• Only use quick-charge NiMH batteries.
2
A
• Additional timer safety function terminates the charging of the batteries
4
if the maximum charging time is exceeded.
• A fully automatic -ΔV charging shutdown for each charging slot ensures that
each battery is charged to its optimal level. It also prevents the batteries from
overcharging.
Charging:
2 or 4 AA/Mignon batteries or 2 AAA/Micro batteries can be charged
simultaneously. AA and AAA batteries cannot be charged simultaneously.
• Set the switch (A) on the front side to the 2 or 4 batteries which are to be
charged.
• Turbo mode: Use the two middle charging slots (B), if only 2 AA batteries use
are charged. Here, the batteries are charged with increased charging current
what shortens the charging time once more.
• AAA batteries can only be charged in the middle charging slots (B).
• As the batteries can heat up considerably during the fast charge, you should
never cover the device and the power supply unit during the charge!
• Insert the batteries in the correct direction.
• Each pair of the 2 charging compartments (B) and (C) is monitored separately.
• The charge state of the battery before charging it is not important.
• Cells of the same size, capacity and charge state can be charged together.
• The charging process begins automatically straightaway when the batteries
have been inserted.
• After the charging process is terminated, the device switches to impulse
trickle charge.
• Batteries can stay in the charger and remain ready for use.
Indicator:
Two LEDs show the current function of the charging device.
Depending on the battery initial state, the changeover to charging end occurs at
different times. When more than one battery is in the charger, the LED does not
indicate the end of the charging process until the last battery is fully charged.
Status of LED
Red LED
Shines constantly
Off
Flashes or Off
NiMH rec. capacity charging current charging time
2 350 - 1300 mAh 350 mA
2 1000 - 2700 mAh 1000 mA
4 1000 - 2700 mAh 700 mA
Status of Charger
Green LED
➞
Off Batteries are charged
➞
Shines constantly Charging terminated – Trickle charge
➞
Off No charging – Defect mode
The defect mode can have the following reasons:
• Normal battery or fully charged NiCD battery inserted
• Normal battery and rechargeable battery mixed
• 2/4 switch is not in correct position
ca. 1.2 - 4.5 h
• Battery inserted the wrong way round: +/- interchanged
ca. 1.2 - 3.2 h
• One or more batteries are defective.
ca. 1.7 - 4.5 h
Find out which battery is defective and dispose of it.
Battery directions:
• The included batteries must be charged before they are used for the first time.
Remove any isolating strips between the batteries and charger.
• Rechargeable batteries only attain maximum charging capacity once they
have been charged/discharged several times over.
• Only charge batteries when they are empty so as to increase their lifespan.
• Totally discharging the batteries should be avoided. Do not completely dis-
charge the batteries in flashlights, watches or fire alarms or else they will be
permanently damaged.
• Batteries discharge by themselves. The rate of discharge is faster the warmer
the ambient temperature is. Store batteries at 2 to 8 degrees (in a refrigerator,
for example).
• Unusable batteries belong in the proper collecting bin of a store or of the
community, and not in household waste!
Safety information:
• NEVER charge alkaline batteries or other conventional disposable batteries as
this could cause an explosion!
• Use only high-quality brand batteries as only these will ensure a long service
life with many charging/discharging cycles.
• Never short-circuit the contacts of the charger/mains adapter!
• Only use the unit in dry rooms and protect it against moisture and dust.
• Protect the charger/power pack from heat; do not cover them and ensure
sufficient ventilation.
• Do not use or open defective mains adapters and chargers. Repairs must only
be completed by an authorized specialist.
• Clean the unit with dry, soft cloths only.
• When not in use, disconnect the unit from the power supply.
• Warning! The mains adapter, just as for all electrical appliances, must be kept
away from children!