Autotek A1800 Benutzerhandbuch Seite 19

INTERCONNECTION EXAMPLE: Highpass/Full Range Mode with
AMPLIFIER 1
Switch Position = HP or FULL
Speaker-System L
2 - 8 Ohms
NOTE!
As option, you are able to connect an additional speaker on the non-occupied speaker terminals of each amplifier.
Therefore the total impedance of each loudspeaker must be 4 - 8 ohms.
HIGHPASS-/FULL RANGE-MODE ON MONO-AMPLIFIERS.
The AUTOTEK A1800 mono amplifier offers with the two operation modes HP (Highpass-Mode) and FULL (Full Range-Mode) the
opportunity, to supply very huge loudspeaker-systems with high power ratings. Together with another additional A1800 amplifier, an
amplifier power of 800 Watt RMS on 2 Ohms per channel is possible.
As option, the non-occupied loudspeaker outputs on each amplifier can be used for an additional loudspeaker-system and with a total
impedance of 4 ohms per per speaker, 400 Watts RMS are possible. This interconnection example ist especially suited for back shelf
installations with two stereo loudspeaker systems.
Besides the additional A1800 amplifier you need for this interconnection example also two separate Y-Connector cables (1 x female on
2 x male.)
A 1 8 0 0
1 Loudspeaker-System and 2 Amplifiers
L R
Optional
Y-Connector
(1F on 2M)
1 9
AMPLIFIER 2
Switch Position = HP or FULL
Speaker-System R
2 - 8 Ohms
Optional
Y-Connector
(1F on 2M)