AEG L 75480 HFL Benutzerhandbuch Seite 24

24 www.aeg.com
Problem
The appliance
does not drain the
water.
The appliance
door is open or
not closed cor-
rectly.
The anti-flood de-
vice is on.
The spin phase
does not operate.
The programme
does not start.
Possible cause
The water inlet hoses
are damaged.
The filters in the water
inlet hoses are blocked .
The water taps are
blocked or are furred
with limescale.
The connection of the
water inlet hoses is not
correct.
The water pressure is
too low.
The water drain hose is
damaged.
The filter of the drain
pump is blocked.
The connection of the
water drain hose is not
correct.
A washing programme
without the drain phase
is set.
The function Rinse &
Hold is on.
The spin phase is off.
The filter of the drain
pump is blocked.
Balance problems with
the laundry load.
The mains plug is not
connected in the mains
socket.
Possible solution
Make sure that the water inlet
hoses have no damages.
Clean the filters. Refer to 'Care
and cleaning'.
Clean the water taps.
Make sure that the connection
is correct.
Contact your local water author-
ity.
Make sure that the water drain
hose has no damages.
Clean the filter of the drain
pump. Refer to 'Care and clean-
ing'.
Make sure that the connection
is correct.
Set the drain programme.
Set the drain programme.
Close the door correctly.
• Disconnect the appliance.
• Close the water taps.
• Contact the service centre.
Set the spin programme.
Clean the filter of the drain
pump. Refer to 'Care and clean-
ing'.
Adjust manually the items in the
tub and start the spin phase
again.
Put in the mains plug.