Maintenance And Cleaning; Cover Filter - Beko DC 1169 Bedienungsanleitung

5

Maintenance and cleaning

Cover filter

Lint and fibres released from the laundry to the air
during the drying cycle are collected in the "Cover
Filter".
C
Such fibre and lint are generally formed during
wearing and washing.
C
Always clean the filter after each drying
process.
C
You can clean the filter and filter area by
vacuum cleaner.
To clean the filter:
1. Open the loading door.
2. Remove the cover filter by pulling it up and
open the filter.
3. Clean lint, fibre, and cotton raveling by hand
or with a soft piece of cloth.
4. Close the filter and place it back into its seat.
C
Clogging may arise on the filter surface after
using your machine for some time; if this
occurs, wash the filter with water and dry it
before using again.
Sensor (models with a sensor)
There are humidity sensors in your dryer that detect
whether the laundry is dry or not.
To clean the sensor:
1. Open the loading door of the dryer.
2. Allow the machine to cool down if drying has
been carried out.
3. Wipe the metal sensors with a soft cloth,
dampened with vinegar and dry them.
C
Clean metal sensors 4 times a year.
A
Never use solvents, cleaning agents or
similar substances when cleaning since these
materials can cause fire and explosion!
Water tank (Products equipped with a
condenser);
The moisture in the damp laundry is taken from the
laundry and condensed. Drain the water tank after
each drying cycle or during drying when "Water tank"
warning light turns on.
C
You can use the water in the water tank in
your steam irons or air humidifiers.
A
Condensed water is not drinkable!
A
Never take out the water tank when the
programme is running!
Water tank may be located in two different places
as indicated below, depending on the model of your
dryer.
- Inside the drawer on the panel
- Behind the kick plate cover
If you forget to drain the water tank, your dryer will
stop during the following drying cycles when the water
tank is full and the "Water tank" warning light will turn
on. If this is the case, press the "Start/Pause/Cancel"
button to resume the drying cycle after draining the
water tank.
To drain the water tank:
1. Carefully remove the water tank by opening
the kick plate cover/pulling the drawer.
2. Drain the water by opening the water tank
cover.
3. If there is lint accumulation in the water tank
cover, clean it and press to close.
4. Place the water tank into its seat.
30 EN