Philips 109B Benutzerhandbuch Seite 80

Regulatory Information
Please find out about the local regulations on how to dispose of your old monitor from your local Philips dealer.
Information for UK only
file:///D|/EDFU/crt_19_6/edoc/german/109B/SAFETY/regs/regulat.htm (14 of 15)2005-08-10 ¤U¤È 01:26:04
RETURN TO TOP OF THE PAGE
WARNING - THIS APPLIANCE MUST BE EARTHED.
Important:
This apparatus is supplied with an approved moulded 13A
plug. To change a fuse in this type of plug proceed as
follows:
1. Remove fuse cover and fuse.
2. Fit new fuse which should be a BS 1362 5A,A.S.T.A. or
BSI approved type.
3. Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it
should be cut off and an appropriate 3-pin plug fitted in its
place.
If the mains plug contains a fuse, this should have a value
of 5A. If a plug without a fuse is used, the fuse at the
distribution board should not be greater than 5A.
Note: The severed plug must be destroyed to avoid a
possible shock hazard should it be inserted into a 13A
socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured in accordance
with the following code:
BLUE - "NEUTRAL" ("N")