Troubleshooting - Grundig GRB 2000 USB Bedienungsanleitung

INFORMATION

Troubleshooting

If a fault occurs, first refer to this information before you
take the device for repair.
If you are unable to rectify the fault using the informa-
tion given here, contact your local dealer or service
specialist.
Under no circumstances should you attempt to repair
the radio recorder yourself, as this would invalidate the
guarantee.
PROBLEM
GENERAL­INFORMATION
No sound
The device does not respond to button
commands
The device suffers malfunctions during
playback
RADIO
Poor radio reception
CD
Playback will not start
The CD player skips tracks
CD-Rs or CD-RWs are not being
played back, or being played back
incorrectly
MP3
MP3 CD plays too fast or slowly
30­
ENGLISH
­ ______________________________________________________
POSSIBLE­CAUSE
The volume setting is too low
The headphones are connected
The batteries are flat
The batteries are incorrectly inserted
The mains cable is incorrectly connected
Static electrical discharge or electrical fast
transient (burst)
­
­
Weak radio antenna signal
Interference from electrical devices such
as televisions, video recorders, computers,
neon lamps etc.
The CD is damaged or dirty
A stored track memory is being played
The RANDOM function is activated
The CD is faulty or the software or
hardware settings were incorrect during
burning
The sampling frequency of 44.1 kHz was
not used
REMEDY
Adjust the volume, unplug the
headphones
Replace the batteries, insert then
correctly
Connect the mains cable properly
Switch off the device, disconnect the
mains cable and plug it in again after
a few seconds
Remove any batteries
VHF (FM): tilt and turn the telescopic
antenna
Keep radio recorder away from
electrical devices
Replace or clean the CD
Switch to normal playback or delete
Switch off the RANDOM function
Check the components of your CD
burner / burner software or change
the CD you are using
Burn a new MP3 CD using the correct
sampling frequency