Radio Mode - Grundig GRB 2000 USB Bedienungsanleitung

RADIO­MODE
Antennas
1
For FM stations (VHF) extend the telescopic antenna.
Note:­
If the FM signal is too strong, it is advisable to push
7
in the telescopic antenna.
Selecting­the­radio­input­source
1 »OFF­ CD­ USB­
Move the
»RADIO« position.
Setting­and­storing­radio­stations
Automatic­station­search
1 Activate the station search by pressing
»PROG/MEM« until the frequency display
changes to rapid run-through.
– The device searches for up to 10 radio stations
and then saves them. After the search has
finished, the station stored in position 01 can be
heard.
Automatic­station­search
1
Activate the station search by pressing
or »UP­ « until the frequency display changes to
rapid run-through.
– The search stops when a programme is found.
Manual­station­search
1 To move the frequency forward in steps, briefly press
»DOWN­ « or »UP­
– The frequency changes in steps of 50 kHz.
­_________________________________________________________
RADIO« switch to the
»DOWN­
« several times.
Storing­stations­on­station­positions
Up to 10 stations in the FM band can be stored.
1
Press »DOWN­
2 Press »PROG/MEM« briefly to activate the memory
function.
3 Select the desired station position with
»ALBUM­MEMORY­UP« or
»ALBUM­MEMORY­DOWN«.
4
Press »PROG/MEM« to save the station.
5
To store more stations, repeat steps
Note:
You can replace a station on a preset with a new
7
one by carrying out steps
above.
Selecting­a­preset­position
1 Select the station preset position with
MORY­UP« or »ALBUM­MEMORY­DOWN«.
Stereo/mono­reception
If the device receives an FM stereo station, »
«
pears in the display. However, if the signal from the FM
stereo station is weak, you can improve the sound qual-
ity by switching to mono reception.
1
Switch to mono reception by pressing
»■­MONO/ST.«.
2 Switch to stereo reception by pressing
»■­MONO/ST.« again.
« or »UP­ « to select the station.
1 to 4.
1 4
to as described
»ALBUM­ME-
ENGLISH
« ap-
)
23­