Wi-Fi Direct - Samsung HT-J7500W Benutzerhandbuch

6. The Network connection fail screen appears.
Use:; buttons to select IP Settings, and then
press the OK button.
7. Select the IP setting field, and then set it to
Enter manually.
8. Select a network parameter to enter (IP
Address, for example), and then press
button. Use the 78 buttons on the remote
control to enter the numbers for the parameter.
Or use the Num keypad to enter a parameter
number. Press and hold the 123 button until
the Num pad appears on the screen. When the
Num pad appears, select a number using the
78:; button and then press the
Use the :; buttons on the remote control
to move from entry field to entry field within a
parameter. When done with one value, press the
OK button.
Press the , or . button to move to another
9.
parameter, and then enter the numbers for that
parameter following the instructions in Step 8.
10. Repeat Steps 8 and 9 until you have filled in all
parameters.
✎
You can get the Network parameter values from
your Internet provider.
11. When finished, select OK, and then press the
OK button. The Security screen appears.
12. On the Security screen, enter your network's
security code or pass phrase. Enter letters by
selecting a letter with the 78:; buttons, and
then pressing the OK
13. When finished, select Done at the right of the
screen, and then press the
product verifies the network connection and
then connects to the network.
14. After the home cinema verifies the network,
select OK, and then press the
✎
You can also begin the Manual Network setup by
going to Settings > Network > Network Status.
K
WPS(PBC)
One of the easiest ways to set up the wireless
network connection is using the WPS(PBC) function.
If your wireless router has a WPS(PBC) button, follow
these steps:
After following Steps 1 to 3 in "Configuring Your
Network Connection" on page 23:
OK
OK button.
button.
OK button. The
OK button.
25
1. In the Network Settings screen, change
Network type to Wireless. The product
searches for and then displays a list of the
available networks.
2. Scroll the list down, select WPS(PBC), and then
press the OK button.
3. Press the WPS(PBC) button on your router
within two minutes. Your product automatically
acquires all the network settings values it needs
and connects to your network after the network
connection is verified.
4. When it is done, highlight OK, and then press
the OK button.
✎
For a WPS connection, set your wireless router's
security encryption to AES. WEP security
encryption does not support a WPS connection.

Wi-Fi Direct

The Wi-Fi Direct function allows you to connect
Wi-Fi Direct devices to the product and each other
using a peer-to-peer network, without a wireless
router.
✎
Some Wi-Fi Direct devices may not support the
DLNA function if connected via Wi-Fi Direct. If
this is the case, change the network connection
method you used to connect the device to the
home cinema.
✎
Wi-Fi Direct transmissions can interfere with
Bluetooth signals. Before you use the Bluetooth
function, we strongly recommend that you turn off
the Wi-Fi Direct function on any device in which
it is currently on.
1. Turn on the Wi-Fi Direct device and activate its
Wi-Fi Direct function.
2. In the Home screen, select Settings, and then
press the OK button.
3. Select Network, and then press the
4. Select Wi-Fi Direct, and then press the
button.
The Wi-Fi Direct devices that you can connect
the home cinema to appear.
- English
OK button.
OK