Error Message - LG F14U2QCN(0~9) Bedienungsanleitung

Troubleshooting guide
Error Messages
Symptom
• Water supply is not adequate in
area.
• Water supply taps are not
completely open.
• Water inlet hose(s) are kinked.
• The filter of the inlet hose(s) are
clogged.
• If water leakage occurred in the inlet hose,
indicator " " will be changed red color.
• Drain hose is kinked or clogged.
• The drain filter is clogged.
• Load is too small.
• Load is out of balance.
• The appliance has an imbalance detection
and correction system. If individual heavy
articles are loaded (e.g. bath mat, bath
robe, etc.) this system may stop spinning
or even interrupt the spin cycle altogether.
• If the laundry is still too wet at the end of
the cycle, add smaller articles of laundry to
balance the load and repeat the spin cycle.
• Ensure door is not open.
• Water overfills due to the faulty water
valve.
• Water level sensor has malfunctioned.
• Over load in motor.
• Water leaks.
36
Possible Cause
Check another tap in the house.
<Fig 1>
Fully open tap.
Straighten hose(s).
Check the filter of the inlet hose.
Clean and straighten the drain
hose.
Clean the drain filter.
Add 1 or 2 similar items to help
balance the load.
Rearrange load to allow proper
spinning.
Close the door completely.
If "
call for service.
Unplug the power plug and call
for service.
Close the water tap.
Unplug the power plug.
Call for service.
Allow the washer to stand for
30 minutes to allow the motor
to cool; then restart the cycle.
Call for service.
Solution
, " is not released,