Installation - Omnitronic LF-01L Bedienungsanleitung

INSTALLATION

Please consider the
installation! The installation must only be carried out by an authorized dealer!
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Before lifting or lowering the telescopic tubes, you must always block a safety area around the stand. This
safety area must have a diameter of 1.5 times the maximum height.
Procedure:
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the loads. If you lack these qualifications, do not attempt the installation yourself, but
instead use a professional structural rigger. Improper installation can result in bodily injury and/or damage to
property.
Step 1: Loosen the fixation screw of the legs. Pull out the legs until the cross struts stand at a 45° angle
to the legs. Tighten the fixation screws of the legs.
Step 2: Attach a speaker system with an appropriate flange on the top end of the stand and loosen the
fixation screw at the telescopic tube. With a load up to 18 kg the telescopic tube is extended
automatically by the integrated gas spring. As soon as you have reached the desired height,
tighten the fixation screw.
Step 3: Caution! The load has to be installed in a balanced way. The carrying capacity of the stand
must never be exceeded. The stand must be set up in a stable way. Make sure all fixation
screws fit tight.
Step 4: For disassembly, first loosen the fixation screw and pull in the telescopic tube completely. Then
tighten the fixation screw and remove the speaker system.
Before taking into operation for the first time, the installation has to be approved by an expert!
DANGER TO LIFE!
DIN 15560-27 and the respective national norms during the
DANGER TO LIFE!
11/12 00055315.DOC, Version 1.1