Transmitter; Battery Charging - XciteRC X-TIDE micro 40002000 Bedienungsanleitung

off the motor. If possible, try to meet it half-way on the shore, until you can control it again.

Transmitter

EN
Steering wheel
1. On / Off Switch: Turns the power of the transmitter ON/OFF
2. Steering wheel: direction right or left
3. Control trim: adjusts the straight-ahead driving
4. Throttle stick: Controls the speed of the model
5. Throttle Trim: adjust the neutral position of the controller (always left in the middle position!)
6. POWER LED: indicates the battery voltage
7. Antenna

Battery charging

WARNING: Be sure to read all safety instructions regarding the use of rechargeable batteries. Charging
may take place only with the supplied charger on a fi re-
proof surface and under constant adult supervision - fi re
or explosion hazard!
• Insert the charger into an AC outlet AC 110-240 V
50/60Hz
• Connect the battery using the 3-pin balancer plug to
the charger (see picture).
• WARNING: the charging cable is polarized,
pay attention to the two guide rails in the connector
housing. The plug must snap into place relatively easi-
ly, do not use force - fi re or explosion hazard!
• During charging, the red LED on the charger lits. A fully
discharged battery takes about 3.5 hours until it is fully
charged - the red LED goes out.
• Unplug the battery from the charger.
• Unplug the charger from the socket when you no lon-
ger need it.
The run time of the X-Tide micro is about 7-10 minutes.
18
POWER-LED
back
Throttle lever
ON/OFF
forward
switch
Cover
Steering
trim
110-240 V AC
50/60 Hz
LED
Battery charging
Throttle trim
FREQUENCY-LED
X-TIDE micro