Gas Cylinder - Napoleon LEX 485 Bedienungsanleitung

4

Gas Cylinder

EN
Use only gas cylinders, which meet national and regional codes. For optimal performance the grill should
be operated on propane. The minimum cylinder size for butane units is 13kg, and for propane units is
6kg. Ensure that the cylinder can provide enough fuel to operate the appliance. If in doubt, check with
your local gas supplier.
• Use caution when handling the cylinder valve.
• Never connect a cylinder, which does not meet local codes.
All cylinders 7kg or larger must be placed outside the enclosure (under the right side shelf) on level
ground. Cylinders smaller than 7kg (maximum size 465mm high by 306mm wide) may be placed inside
the enclosure, on the right side of the bottom shelf. Only cylinders connected to the appliance may be
stored in the enclosure, or close to the appliance. Spare cylinders must not be stored in the enclosure, or
in close proximity of an operating unit. Cylinders must not be exposed to extreme heat or direct sunlight.
WARNING!
unit. Hoses that contact high temperature surfaces may melt and leak, causing a fire.
Cylinder Connection: Ensure that the gas regulator hose is kink free. Remove the cap or plug from the
cylinder fuel valve. Tighten regulator to cylinder valve. Leak test all joints prior to using the barbecue. A
leak test must be performed annually, and each time a cylinder is hooked up, or if a part of the gas system
is replaced.
Example Cylinder
WARNING!
•
•
•
•
•
•
Gas Hose
• If the hose and regulator are not included by the manufacturer, then only hoses and regulators which
meet national and regional codes are to be used.
• Ensure that the hose does not come into contact with grease, other hot drippings, or any hot surfaces
on the appliance.
• Check hose regularly. In the case of rips, melting or wear, replace hose before using the appliance.
• The recommended hose length is 0.5m. The hose must not be longer than 1.5m.
• Ensure that the hose is twist and kink free when installed.
• Replace the hose before expiry date printed on the hose.
www.napoleongrills.com
Ensure that the hose is routed to maintain proper clearance to the underside of the
306mm
465mm
Do not route hose underneath drip pan.
Do not route hose between space in bottom shelf and back panel.
Do not route hose over top of back panel.
Ensure all connections are tightened using two wrenches. Do not use Teflon tape or pipe dope on
any hose connection.
Ensure the hose does not contact any high temperature surfaces, or it may melt and leak causing a
fire.
Do not use enclosure to store excess hose, as there is a greater chance of the hose contacting a hot
surface, it may melt and leak causing a fire.
N415-0275CE-GB-DE OCT 23.17