GB
13
Container seal
14, 15, 16 Ventilating hose, valve cover, diaphragm
17
Stir stick
Lubricating grease
16. Accessories
The CLICK&PAINT SYSTEM with additional spray attachments and accessories offers
the right tool for each work.
Further information about the WAGNER range of products for renovating is available
under www.wagner-group.com
17. Correction of Malfunctions
Problem
No coating material
emerges from the
nozzle
Coating material
drips from the
nozzle
Atomisation too
coarse
10
Spare Parts List (Fig. 12)
Cause
•
Nozzle clogged
•
Material volume setting
turned too far to the left (-)
•
No pressure build-up in
container
•
Container empty
•
Feed tube loose
•
Feed tube clogged
•
Coating material assembly
at air cap, nozzle or needle
•
Nozzle loose
•
Nozzle seal worn
•
Nozzle worn
•
Material volume too large
•
Material volume adjusting
screw turned too far to the
right (+)
•
Nozzle contaminated
•
Viscosity of coating material
too high
•
Too little pressure build-up
in container
•
Air filter heavily soiled
FENCE & Decking SPRAYER
Remedy
➞ Clean
➞ Turn to the right (+)
➞ Tighten container
➞ Refill
➞ Insert
➞ Clean
➞ Clean
➞ Union nut tighten
➞ Change
➞ Change
➞ Turn material volume
adjusting screw to the
left (-)
➞ Clean
➞ Dilute further
➞ Tighten container
➞ Change
2323 039
2304 027
2304 419
2315 539