KKT KOLBE BASE Benutzerhandbuch Seite 34

Installation
1
Dübel
2
ST4-Schrauben
Open the glass panel and remove the aluminum grease filter. Mark the two holes
for the installation from the inside of the hood.
Take the hood back down again. Drill the two ø 8 mm holes at the marked
locations. Insert four wall plugs into the holes and four screws into the wall.
Hang the extractor hood back in the wall bracket and tighten the four screws on
the inside of the extractor hood.
Inner chimney
Chimney bracket
Outer chimney
Use 2x ST4 x 8-mm screws to connect the upper and lower shaft together. Before
attaching the bracket to the wells, measure and opt for a level of attachment.
Please note: When the vent outside mode, the vent should be downward and inser-
ted into the lower chimney. Make sure the vents are covered by the lower chimney.
34