Installing The Flight Battery; Troubleshooting Guide - XciteRC FLYBARLESS245 Bedienungsanleitung

IDLE: switch between speed and pitch control (switch position N or 0).
EN

Installing the flight battery

•
Put the throttle stick to the lowest position.
• Turn on the transmitter. Check the model memory (please see first flight preparation).
• Install the flight battery in the battery holder, connect the battery with 4-in-1 main board, place the heli-
copter static level next to the transmitter.
• Waiting several seconds, the main rotor flap up and down twice, it means the heli successfully bind to the
transmitter. Please move the heli after the binding finished.

Troubleshooting guide

Problem
LED on 3-in-1 board flashes con-
stantly and operating no function
after connecting battery to heli-
copter.
The helicopter do not response
after connecting batteries to re-
ceiver.
When push the throttle pole,the
rotor do not rotate and the LED
on Receiver flashes constantly.
20
Possible cuase
Transmitter is not bound to re-
ceiver.
Check whether the transmit- ter
and helicopter connecting to po-
wer; check the voltage of trans-
mitter and helicopter's bat- tery;
battery pole flake contact is not
good.
Low battery voltage; batteries
connection is not good.
Installing the Flight Battery
Solution
Bind transmitter to receiver.
Open the transmitter, make sure
the batteries connecting is good;
replace and charge transmitter
batteries, make sure the battery
pole flake contact is good.
Replace and charge the batte-
ries, reconnect the batteries to
the receiver board.
XciteRC Flybarless 245 3D Brushless