Antenna Connections - Clatronic CTV 789 Bedienungsanleitung

Connecting other Playback Devices

Antenna connections

48
05_CTV789_GB 48
Digital
Connect the Coaxial cable for transmission of digital Audio signals to your play-
back device or your amplifi er.
1. Insert the audio plug into the socket on the right-hand side of the device
(Fig. 1/5).
2. Plug the Audio jack into the corresponding socket on your playback device or
your amplifi er.
In order to play back the picture from another playback device (e.g. digital came-
ra) on the LCD screen, connect the audio/video cable to the AV IN socket (Fig.
1/3) and the other end to the playback device. Press the AV IN/OUT button (Fig.
1/15) in order to switch the device over to AV IN operation.
NOTE:
If you would like to display the picture from the internal DVD player on the
LCD screen, press the AV IN/OUT button (Fig. 1/15) again.
Antenna Input (Fig. 1/25)
NOTE:
Please ensure that it is possible to receive DVB-T signals in your area.
Information on the transmission area is available on the Internet under:
http://www.ueberallfernsehen.de, or from your specialist dealer.
This device has a built-in DVB-T receiver.
In order to be able to receive digital terrestrial channels with the built-in DVB
receiver it is necessary to connect your permanently installed house aerial.
If you are located in the central section of the transmission area you can also use
an optional passive or active DVB-T aerial.
• Connect the cable from your DVB-T aerial system or your DVB-T room aerial
to the ANT. socket on the left-hand side of the device.
26.03.2008, 15:06:00 Uhr