Clatronic CTV 789 Bedienungsanleitung Seite 65

Teletext
05_CTV789_GB 65
In order to access the EPG menu, press the PROG/EPG (Fig. 2/12) button during
DVB-T operation. The EPG information window appears:
• Current channel (1).
• Current programme (2).
• Following programme (3).
• Current date and time (4).
Use the cursor buttons (Fig. 2/8) to select the „Channel" line and confi rm with
the ENTER (Fig. 2/7) button in order to display more EPG information.
The displayed window shows the programmes of the same day. With the cursor
buttons (Fig. 2/8) you can scroll through the information.
The buttons that you can use for the navigation are shown at the bottom left-hand
edge. The „ " arrow corresponds to the ENTER button.
Additional information can be called up with the number keys (1-4).
• 1. Info: Further information on the programme.
• 2. Prev: Programme of the previous day.
• 3. Next: Programme of the following day.
• 4. Detail: Contents of the programme.
Reserving Programmes
From the EPG menu it is possible to reserve programmes.
1. Use the cursor buttons (Fig. 2/8) to select the desired programme and press
the ENTER (Fig. 2/7) button to confi rm.
2. An information window appears. Select „OK" to reserve the programme or
„Cancel" to cancel the procedure. Confi rm your selection with the ENTER
button.
The reserved programme is now listed in the DVB-T menu (reserved program-
mes).
Deleting reserved programmes
1. If you would like to delete the reserved programme again, select „channel
setup/reserved channel/start" in the DVB-T settings menu.
2. Use the cursor buttons (Fig. 2/8) to select the corresponding programme
and confi rm with the ENTER button (Fig. 2/7).
3. Confi rm the confi rmation prompt with the ENTER button.
Press the ANGLE/TTX button (Fig. 2/4) to call up the teletext function. Enter the
desired teletext page with the help of the numerical buttons (Fig. 2/3). The
number you have entered is shown in the top left-hand corner of the screen.
After you have entered the desired teletext page number your television set
searches for the page. As the teletext pages cannot all be transmitted at the same
time it may take a few seconds until your set has found the page.
For all teletext operators page 100 shows the list of contents.
65
26.03.2008, 15:06:22 Uhr