Santec SNC-4302 Kurzanleitung Seite 2

Kurzanleitung / Quick installation guide
SNC-4302
To operate the IP dome camera, please follow these steps:
1. Install the camera in the desired location.
Connector Definition
1 Reset button
2 Lens
3 Focus fixed screw
4 Tilt fixed screw
5 Micro SD card slot
2. Connect the camera to power using PoE (PoE switch or PoE injector required).
The SANTEC SNC-4302 can only be supplied with power via PoE.
3. Connect the camera to the network using a LAN cable.
The network LED lights up in orange.
4. Insert the CD (included in the delivery) into your PC/laptop
and install the IP-finder.
5. The IP-finder displays an IP address for the camera. Double-click on the IP address
and the Internet Explorer comes up automatically. In case this doesn't work, you may
also enter the IP address (as shown by the IP-finder) manually into the Internet
Explorer. Using the IP-finder, another IP address can be assigned to the camera, if
required.
Note:
The camera comes with a default IP address:
Default IP address:
User name:
Pass word:
Please refer to the user manual for further information on camera configurations.
Subject to technical changes. Errors excepted.
QUICK INSTALLATION GUIDE
IP camera SNC-4302
1. Prepare a PC/laptop with an Ethernet link to the network.
2. Connect the LAN port (RJ45) of the camera to a network
switch/hub.
3. Check the network LED status.
192.168.1.168 (or by DHCP, if available)
admin
9999
Description
Reset to factory default.
Turn the lens clockwise/counter-clockwise to adjust the
focus.
Loosen the screw to adjust the lens.
Loosen the screw to adjust the tilt angle.
For video recording storage.
Version 1.0sfi/0312/dt-engl/A5