Teaching-In To A Homematic Central Control Unit - HomeMatic HM-LC-Sw1-Pl-DN-R3 Bedienungsanleitung

Start-up
• After teaching-in, the device LED of the switch actuator will stop
flashing.
After successfully teaching-in the device, it can be switched on and off
e.g. by a HomeMatic remote control.
If no teach-in operations are carried out, teach-in mode is
exited automatically after 20 seconds. If other devices are also
in teach-in mode, they will be taught-in.
5.2.2

Teaching-in to a HomeMatic Central Control Unit

Your device can be conveniently
• controlled and configured,
• connected directly to other devices or
• used in Central Control Unit programs
by using the HomeMatic software "WebUI". Therefore, your switch ac-
tuator has to be taught-in to the HomeMatic Central Control Unit first.
New devices are taught-in to the Central Control Unit via the Home-
Matic „WebUI".
As soon as a device has been taught-in to a Central Control
Unit, it can only be connected to other components via this
unit.
10
Each device can only be taught-in to one Central Control Unit.
During teach-in, please make sure you maintain a distance of
at least 50 cm between the HomeMatic devices and the
Central Control Unit.
To teach-in your device to the Central Control Unit, proceed as follows:
• Open the "WebUI" user interface in your browser. Click the "Teach-
in devices" button on the right-hand side of the screen.
• To activate teach-in mode, click "Start teach-in mode" in the next
window.
• Teach-in mode remains activated for 60 seconds. An information
Start-up
11