Possible Problems And How To Solve Them; Maintenance And Repairs - MPVTruma MicroDrop Gebrauchsanweisung

Possible Problems and how to
solve them
If the device does not switch on:
1. make sure the plug is firmly fitted to the
wall socket;
2. the thermal protector might have been
released. The thermal protector may be
released for the following reasons:
– the device has been in operation for a
too long time;
– the device was used near heaters or in
hot environments;
– the air vent openings (pic. A / 7) are
obstructed and do not allow for the
motor ventilation.
In this case, set the ON / OFF switch to
"O" and let it rest for at least 15 minutes.
If the device does not nebulize, or only
very weakly, check the following points:
1. make sure that the ends of the air tube
are fitted tightly onto the main unit and
onto the nebulizer;
2. check whether the nebulizer is empty
from medication or full of an excessive
medication quantity (max. 7 ml);
3. check whether the nebulizer nozzle is
obstructed;
4. check whether the air conduction cone
is inserted (pic. E).
22

Maintenance and Repairs

In case of failure, address to qualified per-
sonnel authorized by MPV TRUMA. Never
open the device. There are no user-
serviceable parts within. The compressor
requires no lubrication or maintenance.