MPVTruma MicroDrop Gebrauchsanweisung Seite 20

Instruction for Use
See nebulizer manual for detailed
information.
Remove the compressor from carrying
case before use.
Check the unit before each use, in order
to check for possible function anomalies
and / or damages due to transport and / or
storage.
When inhaling, sit upright and relaxed at a
table and not in armchair as otherwise you
will constrict your respiratory passages and
impair the effect of inhalation.
1. As soon as you have unpacked the device,
check it for visible damages or defects.
In particular, check for cracks in the plastic
housing, which could expose electrical
components.
2. Check for accessories integrity.
3. Before using the device, proceed with
the cleaning operations as described in
the "CLEANING AND DISINFECTION"
section.
4. Open the nebulizer by turning the top in
an anticlockwise direction (pic. D).
5. Make sure the air conduction cone is
properly fitted onto the air conduction
cone inside the nebulizer chamber (pic. E).
6. Put the prescribed medication dose into
the nebulizer chamber (pic. F). The
graduated scale can be useful to control
the correct medication quantity.
7. Close the nebulizer by turning the two
parts in a clockwise direction, paying
attention that they are thoroughly sealed.
8. Connect the wing plug of the air tube to
the nebulizer (pic. G) and the other end
to the air outlet on the device (pic. A / 4).
20
9. Use the CalimeroJet nebulizer with
inhalation valve only with mouth piece
having exhalation valve. When using
the masks, it is not necessary to keep
inhalation valve: replace it and connect
the masks directly onto the nebulizer
(pic. I). See nebulizer manual.
10. Plug the device to the wall socket,
making sure that the electrical rating
shown on the rating plate on the
bottom of the unit corresponds to
your main voltage.
11. To start the treatment, switch the device
on by pressing the switch (pic. A / 2)
in the front of the device onto the "I"
position.
12. Inhale the aerosol solution using the
prescribed accessory.
13. When the treatment has been comple-
ted, switch the unit off by setting the
switch position "O" and disconnect the
plug from the wall socket.
14. Wash the nebulizer and accessories as
described in the "CLEANING AND
DISINFECTION OF THE ACCESSORIES"
section.
15. Put the nebulizer, accessories and
power cord inside the carrying case
(pic. A / 14).