MPVTruma MicroDrop Gebrauchsanweisung Seite 19

8. Make sure that the electrical rating
shown on the rating plate on the bottom
of the unit corresponds to your main
voltage and frequency before plugging
in the device.
9. If the power plug provided with the
device does not fit your wall socket,
have the plug changed by an electrical
appliance dealer. Do not use any adap-
ter, simple or multiple, and / or exten-
sion cable. In case their use is necessary,
make sure they are in compliance with
safety standards, paying attention they
do not exceed the maximum load.
10. Do not leave the unit plugged when not
in use: unplug the device from the wall
socket when not operating.
11. Follow the manufacturer's instructions
for installing the device. The manufac-
turer cannot be held responsible for any
damage caused to persons, animals or
things by incorrect installation.
12. The power supply cord cannot be re-
placed by the user. In case the power
supply cord becomes damaged, address
to the technical servicing authorized
by the manufacturer for replacement.
13. The power supply cord should always
be fully unwound in order to prevent
dangerous overheating.
14. Before performing any maintenance
or cleaning operation, disconnect the
device from the main supply, by un-
plugging it or by turning the main supply
switch off.
15. Some parts of the unit are so small that
they could be swallowed by children;
do not let unattended children have
access to the unit.
16. If you decide not to use the device any
longer, it is recommended to dispose of
it according to the regulations in force.
17. Remember to:
– use this device only with medications
prescribed by your doctor;
– make the treatment only using the
accessory recommended by your doctor
for the therapy;
Device Safety Systems
Thermal Protector
The inhalation device is provided with a
temperature protection device which is
released when the device is overheating
switching the unit off.
English
19