Setting The Priority; Setting The Internal Chime - UNIelectronic UPM 8006 Bedienungsanleitung

2.3 Setting the Priorities
Push ‚Talk' key (10) and ‚Zone 4' key(5) simultaneously until the 'Talk' LED (7) and 'Zone 4' LED
(5) start blinking.
The LEDs next to the zone keys 1 and 2 indicate the current priority mode.
Serial Priority
(MIC 1 over Mic 2, MIC 2
over MIC 3, MIC 3 over MIC
4, MIC 4 over MIC 5 , MIC 5
over MIC 6)
By pushing the ‚Zone 4' key you can select the different priority modes.
To store a particular priority mode press the ‚Talk' key (10).

2.4 Setting the Internal Chime

The internal chime of the UPM 8006 works independent of the chime of the UCA 8240.
If more than one UPM 8006 are connected to the UCA 8240 the desktop mic with address 1
determins the chime mode that then is used for all UPM 8006 connected.
Push ‚Talk' key (10) and ‚Zone 3' key(5) simultaneously until the 'Talk' LED (7) and 'Zone 3' LED
(5) start blinking.
The LEDs next to the zone keys 1and 2 indicate the current priority mode.
Chime off
By pushing the ‚Zone 3' key (5) you can select the different chime modes.
To store a particular chime press the ‚Talk' key (10).
Block Priority Conference Priority
(The mic being used first of
all has priority and cannot
be interrupted by any of the Interruption by annother
other mics)
1-tone chime
(Only one mic can be (All mics can be operated
operated at a time.
mic is possible.)
2-tone chime 4-tone chime
Mixing Mode
in parallel).
11