Programming - UNIelectronic UPM 8006 Bedienungsanleitung

2. Programming

2.1 Setting the bus address
If there are more than one UPM 8006 connected, the units have to work with their individual bus
address.
Configuration of the address as follows:
Please press together the "Talk" key (10) and the "Zone 6" key (5) and keep them pressed until the
"Zone 6" LED (5) start blinking.
The LED's of zone buttons 1 to 4 indicate the currently used address.
address 1
address 5
By pressing the "Zone 6" (5) key you can step trough the different address numbers.
To store the selected address, please press the "Talk" key (10), again.
2.2 Setting the microphone sensitivity
Push ‚Talk' key (10) and ‚Zone 5' key(5) simultaneously until the 'Talk' LED (7) and 'Zone 5' LED
(5) start blinking.
The LEDs next to the zone keys 1-3 indicate the mic sensitivity.
Min. Sens.
Pushing the ‚Zone 5' (5) changes the mic sensitivity.
To store a particular sensitivity press the 'Talk' key (10)
10
address 2
address 6
- -
address 3 address 4
address 7 address 8
- - Max. Sens.