Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Plasma Ball Effect Light
Item no. 59 13 54
1.
Intended use
This product is intended to provide stylish lighting effects in living areas. Power is supplied either by four AA
batteries (not included) or by an optional power supply unit. The product is only to be used indoors in dry
conditions.
For safety and approval purposes (CE), you must not rebuild and/or modify this product. If you use the product
for purposes other than those described above, the product may be damaged. In addition, improper use can
cause hazards such as short circuiting, fire, electric shock etc. Read the instructions carefully and keep them.
Make this product available to third parties only together with its operating instructions.
2.
Delivery content
•
Plasma ball
•
Operating instructions
3.
Safety instructions
Read the operating instructions carefully and especially observe the safety information.
If you do not follow the safety instructions and information on proper handling in this
manual, we assume no liability for any resulting personal injury or damage to property.
Such cases will invalidate the warranty/guarantee.
Persons / Product
•
The device is not a toy. Keep it out of the reach of children and pets.
•
Do not leave packaging material lying around carelessly. These may become dangerous playing material
for children.
•
Protect the product from extreme temperatures, direct sunlight, strong jolts, high humidity, moisture,
flammable gases, vapours and solvents.
•
Do not place the product under any mechanical stress.
•
If it is no longer possible to operate the product safely, take it out of operation and protect it from any
accidental use. Safe operation can no longer be guaranteed if the product:
-
is visibly damaged,
-
is no longer working properly,
-
has been stored for extended periods in poor ambient conditions or
-
has been subjected to any serious transport-related stresses.
•
Please handle the product carefully. Jolts, impacts or a fall even from a low height can damage the
product.
•
Also observe the safety and operating instructions of any other devices which are connected to the
product.
(Rechargeable) batteries
•
Correct polarity must be observed while inserting the (rechargeable) batteries.
•
(Rechargeable) batteries should be removed from the device if it is not used for a long period of time to
avoid damage through leaking. Leaking or damaged (rechargeable) batteries might cause acid burns when
in contact with skin, therefore use suitable protective gloves to handle corrupted (rechargeable) batteries.
•
(Rechargeable) batteries must be kept out of reach of children. Do not leave (rechargeable) batteries lying
around, as there is risk, that children or pets swallow them.
•
All (rechargeable) batteries should be replaced at the same time. Mixing old and new (rechargeable)
batteries in the device can lead to (rechargeable) battery leakage and device damage.
•
(Rechargeable) batteries must not be dismantled, short-circuited or thrown into fire. Never recharge non-
rechargeable batteries. There is a risk of explosion!
Miscellaneous
•
Consult an expert when in doubt about operation, safety or connection of the device.
•
Maintenance, modifications and repairs are to be performed exclusively by an expert or at a qualified
shop.
•
If you have questions which remain unanswered by these operating instructions, contact our technical
support service or other technical personnel.
4.
Principle of function
This plasma lamp consists of a transparent glass ball filled with different gases at low pressure. On the inside
of the glass ball there is a smaller glass ball that serves as an electrode. If a high frequency alternating voltage
is connected, flashes are created that reach from the inner to the outer glass ball. If, for example, a hand is
placed on the glass, the electric field changes. A visible light beam is created from the inner light ball to the
point of contact.
5.
Inserting/replacing batteries
1.
Open the battery compartment on the underside of the product.
2.
Insert four AA batteries (not included) into the battery compartment, observing the correct polarity. Also
observe the polarity labelling inside the battery compartment.
3.
Close the battery compartment again.
Replace the batteries when the light effect becomes visibly dimmer.
If required, you can operate the product from an optionally available power supply unit. The
connector is mounted laterally on the base.
6.
Operation
•
Never try to remove the glass dome of the light fixture.
•
Never open the casing of the plasma light fixture.
Version 08/11
•
Do not operate the plasma light fixture unattended.
•
Check the plasma light fixture and power supply unit for damage from time to time.
•
Touch the glass dome only when your hands are dry. Never place metallic objects or
other conductive objects on it.
•
Never keep your hands on the glass dome for a long time because this could cause
burns on your skin.
•
Never operate the plasma light fixture when the glass dome is damaged.
1.
Place the product on a stable surface.
2.
Using the switch on the side, switch the product on (position ON) or off (position OFF).
7.
Cleaning
•
Always turn the device off before cleaning. If you operate the product from a power supply unit, disconnect
the power supply unit from the mains outlet.
•
To clean the outside, it is sufficient to use a dry, soft and clean cloth.
•
Clean the glass globe very carefully, otherwise you may scratch it. Never use aggressive cleaning agents.
8.
Disposal
Product
Electronic devices are recyclable waste and must not be disposed of in the household waste.
At the end of its service life, dispose of the product according to the relevant statutory
regulations.
Remove any inserted (rechargeable) batteries and dispose of them separately from the product.
(Rechargeable) batteries
You as the end user are required by law (Battery Ordinance) to return all used batteries/rechargeable batteries.
Disposing of them in the household waste is prohibited.
Contaminated (rechargeable) batteries are labelled with this symbol to indicate that disposal
in the domestic waste is forbidden. The designations for the heavy metals involved are: Cd =
Cadmium, Hg = Mercury, Pb = Lead (name on (rechargeable) batteries, e.g. below the trash
icon on the left).
Used (rechargeable) batteries can be returned to collection points in your municipality, our stores
or wherever (rechargeable) batteries are sold.
You thus fulfil your statutory obligations and contribute to the protection of the environment.
9.
Technical data
Operating voltage:
Current consumption:
Optional power supply:
Dimensions (Ø x H):
Weight:
© 2011 by Conrad Electronic SE.
6 V/DC (4 AA batteries or, alternatively, an optionally available power supply unit)
max. 800 mA
Output voltage:
6 V/DC
Output current:
min. 800 mA
Plug Ø (inner / outer):
2.1 mm / 5.5 mm
100 x 150 mm
160 g
These operating instructions are published by Conrad Electronic SE,
Klaus-Conrad-Straße 1, D-92240 Hirschau/Germany.
All rights including translation reserved. Reproduction by any method, e.g.
photocopy, microfilming, or the capture in electronic data processing systems
require the prior written approval by the editor. Reprinting, also in part, is prohibited.
The operating instructions reflect the current technical specifications at time of print.
We reserve the right to change the technical or physical specifications.
V1_0811_02-SB
Werbung
