Hama BTCK-10B Bedienungsanleitung Seite 7

• Continue according to 5.1. Bluetooth Pairing
Setup.
• After the second terminal device has been
connected, turn the hands-free set off and then
back on.
• The hands-free set will automatically connect to
the last two terminal devices paired.
Note – Disabling multi-pairing
• To disable the multi-pairing function, press
and hold the -button (6) for approx. 3
seconds until you hear a tone.
• The hands-free set will automatically connect
to the last terminal device paired.
5.4. Hands-free function
Note
• Note that support for certain key functions
may vary depending on your terminal device.
• For more information, please refer to the
operating instructions of your terminal device.
Making a call
• Dial the number directly on your terminal device
to make a call.
Voice dialling function
• Check that your mobile phone supports voice
dialling.
• Briefly press the
will hear a short tone.
• The mobile phone's voice control will be activated.
• Start a call as described in your mobile phone's
operating instructions.
• Speak the name of the contact you wish to call.
6
-multifunction button (7). You
• If the voice entry is associated with a phone
number that is saved on your mobile phone, the
number will be dialled.
Accepting calls
• Press the -multifunction button (7) once to
answer an incoming call.
Rejecting an incoming call
• Press and hold the
for approx. 2-3 seconds to reject an incoming call.
Ending a call
• During a call, press the -multifunction button
(7) once to end the call.
Redial
• Briefly press the -multifunction button (7)
twice to call the last number.
• You will hear a short tone.
Forwarding a call
• During the call, press and hold the
-multifunction button (7) for approx. 3 seconds
to forward the call from the hands-free set to the
terminal device or from the terminal device to the
hands-free set.
Taking a second call while a call is in progress
• Press the -multifunction button (7) twice briefly
to put the current call on hold and accept an
incoming second call.
Rejecting a second call while a call is in progress
• Press and hold the -multifunction button (7) for
approx. 2-3 seconds to reject an incoming second
call and continue the current call.
Switching between two calls
• Press the -multifunction button (7) to switch
between the two calls. The other call will be held
until you switch back to it or it is ended.
-multifunction button (7)