Werbung
OH 66 module commissioning procedure:
(Parameter menu see on the following pages)
1.
Connect CVBS or SDI signal to BNC connector of channel A or channel B.
Connect Audio signal to stereo jack socket 3.5 mm of channel A or channel B.
2.
Switch on the basic unit with OH 66.
3.
The status LED of channel A/B is flashing red - Modulator starts.
4.
The status LED of channel A/B is flashing yellow - MPEG Encoder starts.
5.
The status LED of channel A/B lights up green - An input signal is detected.
Quick setup
Select the channel, for setup, in the menu Channel.
6.
7.
Select input signal type:
In-Para:
8.
Select audio signal source if the SDI input is used:
In-Para:
In-Para:
9.
Select the content for encoding:
MPGPara:
10.
Set program name:
TS-Para:
11.
Set provider name:
TS-Para:
12.
Set network name:
NITPara
13.
Select the output modulation type:
Out-Para:
14.
Set the output frequency:
Out-Para:
15.
For channel B, repeate setup from step 6.
16.
Quit module menu, to save parameters.
- 6 -
In-Src
analog
SDI
A-Src-L
DigGrp 1
A-Src-R
DigGrp 2
Encode
A/V
Audio
off
PgmName
Encoder Progr. A
Provid.
WISI MPG Encoder (16 characters, selectable)
Network
WISI MPG Network (16 characters, selectable)
ModType
DVB-C
DVB-T
ClrCarr
F-Out
474.00
(for analog A/V signals)
(for SDI signals)
(audio source left digital group 1)
(audio source right digital group 2)
(TV program with audio and video)
(Radio program only audio)
(Channel is inactive in TS)
(16 characters, selectable)
(output frequency in MHz)
Werbung
