Installation Des Icp Raid Controllers; Icp Raid Controller Layout - ICP GDT8x24RZ Benutzerhandbuch

Hardware Installation
Abbildung 2-1. ICP RAID Controller Layout
LEDs on Reverse Side:
P66 = 66MHz PCI Clock
green
P
green
S
red
T
green
A
yellow
B
yellow
Data in Cache
red
Flashing if Data in
Cache Memory (only for
GDT8x24RZ+ or
GDT8x24RZ+BBU)
2.1.2

Installation des ICP RAID Controllers

1. Schalten Sie das Computersystem aus.
2. Entfernen Sie alle Spannungskabel und öffnen Sie das Gehäuse.
3. Stecken Sie den ICP RAID Controller in einen freien PCI Steckplatz. Siehe auch
Abbildung
12
SCSI Channel A
= Power Good (3.3 Volt)
= On in Recovery Mode
= Internal Data Transfer
= Activity Channel A
= Activity Channel B
BBU (opt)
Mounting Holes*
RAIDYNE Chip (opt)
Cluster Chip (opt)
Do not use connectors
that are not mentioned
2-2.
SCSI Channel B
BBU (opt) *BBU option only for
Connector* GDT8x24RZ+ and
GDT8x24RZ+BBU
Hardware Installations- und Benutzerhandbuch
SCSI Terminator A/B
Right = Auto
Left = on
Open = off
SCSI Terminaton Power Ch A/B
Set = Supply Termpwr
Open = Termpwr not Supplied
SCSI Channel A
SCSI Channel B
FRU Jumper
Uppper = Recovery Mode
Lower = Normal Mode
LED Connectors for:
- Sum Activity (A or B)
- Activity Channel A
- Activity Channel B
- External Alarm