Restore Factory Settings - HomeMatic HMIP-SWDO Bedienungsanleitung

1x orange and
1 x green light-
ing (after insert-
ing battery)
8

Restore factory settings

The factory settings of the device can be re-
stored. If you do this, you will lose all your set-
tings.
To restore the factory settings of the window / door con-
tact, please proceed as follows:
Pull the cap (D) off the electronic unit (B) (see
•
figure 2).
• Remove the (old) battery.
• Insert the battery ensuring that the polarity is cor-
rect and press and hold down the system but-
ton (E) for 4s at the same time, until the LED will
quickly start flashing orange (see figure 4).
• Release the system button again.
• Press and hold down the system button again for
4s, until the status LED lights up green.
• Release the system button to finish the proce-
dure.
The device will perform a restart.
Test display
Restore factory settings
Once the test dis-
play has stopped,
you can continue.
39