HomeMatic HMIP-SWDO Bedienungsanleitung Seite 35

below with your index finger and thumb and pull
it forward (see figure 2). You will find the battery
compartment below (C).
• Insert a new 1.5 V LR03/micro/AAA battery into
the battery compartment (C), making sure that
you insert them the right way round (see figure 3).
• Please pay attention to the flashing signals of the
device LED while inserting the batteries (see „7.4
Error codes and flashing sequences" on page
37).
Put the cap (D) back to the electronic unit (B).
•
Once the battery has been inserted, the window / door
contact will perform a self-test (approx. 2 seconds). Af-
terwards, initialisation is carried out. The LED test display
will indicate that initialisation is complete by lighting up
orange and green.
Never recharge standard batteries. Do not throw
the batteries into a fire. Do not expose batteries
to excessive heat. Do not short-circuit batteries.
Doing so will present a risk of explosion.
Used batteries should not be disposed of with
regular domestic waste! Instead, take them to
your local battery disposal point.
Changing battery
35