OEG KSF-Pro Bedienungsanleitung Seite 6

Safety
The controller installation can be done only by a qualified technician according to low
voltage installation regulations of IEC 60364, VDE 0100 and VDE 0116. The hydraulic
installation must comply with DIN 4751-1 and DIN 4751-2.
Before wiring check if the main switch is OFF.
Controller installation
The controllers are available with the H2 case - suitable for installation on boiler enclosure. Before mounting
take off the see-trough safety cover and both fixing screws. Take the controller module out from the H2 case,
as seen on picture above.
INSTALLATION MANUAL
INSTALLATION MANUAL
R
6
1 - fixing screws
2 - H1 case
3 - controller module
4 - see-trough safety cover
5 - case holder - console
6 - empty controller slot